Sipeed Tang Primer 20K Lite Ext-Board Gowin GW2A FPGA GoAI Core Board Minimum System Single Board Computer Onboard 128MB bits DDR3 RAM 828K B-SRAM Support RGB DVP PMOD DIP

Sipeed Tang Primer 20K Lite Ext-Board Gowin GW2A FPGA GoAI Core Board Minimum System Single Board Computer Onboard 128MB bits DDR3 RAM 828K B-SRAM Support RGB DVP PMOD DIP

About this item

High-performance DSP: Sipeed Tang Primer 20K Core Module board is a SODIMM package, uses GW2A-LV18PG256C8I7 as the main chip, and has multiple internal resources, such as high-performance DSP, high-speed LvDs interface, and BSRAM resources, on-boardDDR3, and PMIC. Users could use this CM board for rapid development and verification, and it's suitable for high-speed and low-cost situations.

Run RISC-V Code: Users can burn the hardware code bitstream file officers/Litex to Gw2A, and then use GW2A as a common MCU. lt can run RISC-V code, conduct RISC-v soft core experiments

Verilog Design: Users use Verilog to design custom hardware functions based on the PicoRV/Litex lP core and C language to write code running on the PicoRV/Litex core.

Rich Peripheral interfaces: Sipeed Tang Primer 20K Dock is equipped with a wealth of peripheral resources, such as onboard USB-JTAG & UART peripheral, Ethernet PHY and RJ45 connector, USB2.0PHY， HDMIl output connector, Audio output circuit and3.5mm connector， RGB screen connector, DVP camera connector.

PMOD interfaces The Sipeed Tang Primer 20K Lite ext-board routes many lOs to double-row pin headers and PMOD interfaces, with which users can easily connect other peripheral modules or circuits for secondary development.

Minimalist IDE: Compared with other FPGA IDEs, the lDE that is used to develop Tang Primer 20K is small, and the hard disk capacity occupied after installation does not exceed 1G.

Product Description

Specification

Brand Name: Sipeed

Demo Board Type: FPGA

Memory：128MB DDR3，13Row x 10Col x 8banks x 16bits

Flash：32Mbits NOR Flash， W25Q32JVS

Debugger：Jtag + Uart，JST SH1.0 8Pins connector

SD card slot 1：Push-pull type

Display：8Pins spi lcd connector

Package：204P DDR3

Available IO：117

RGB Interface：1x RGB565 40P FPC Connector

DVP Interface：1x 24P FPC Connector

Mic array Interface：1x 10P FPC Connector

Touch Interface: 1x 4P FPC Connector

PMOD Interface: 4

3.5mm headphone Jack: 1x LPA4809MSF driver

DIP switch:1x 5P DIP switch

Slide switch: 1x Switch USB function

Package Content

1x Sipeed Tang Primer 20K Lite ext-board

1x Sipeed Tang Primer 20K Core Broad

1x RV debugger plus

1x Type-CData Cabble

1x 8P 1.0mm to 2.54mm Terminal wires